What should be attention when using dry mortar mix machine
Author：ANT CONSTRUCTIONS Comefrom： Createdate：2020/7/25 16:04:43 Hits：25
What should be attention when using dry mortar mix machine
With the development of society and the improvement of living standards, people have higher and higher requirements for the quality of buildings. This requires the materials used in the construction to meet the relevant standards, but also requires the production of dry mortar enterprises and dry mortar production line enterprises to meet the standards. The following dry mortar production line in the daily use of the need to do a simple introduction.
What should be attention when using dry mortar mix machine
1. Remove the accumulated material in the hopper of dry mortar production line in time to make the sensor return to zero normally.
2. Check whether the lubricating oil at each lubricating point is enough, and the oil atomizer in the air circuit system should keep enough oil.
3. Check whether the motors and electrical appliances are overheated and abnormal noise, whether the instrument indication is normal and whether the signal system is in good condition.
4. Keep the machine and the surrounding environment clean.
5. Frequently check and adjust the cylinder, butterfly valve and solenoid valve to make the opening and closing meet the requirements.
6. Check all systems regularly, and deal with ash leakage, air leakage, oil leakage and leakage in time.
7. The mixer and discharge hopper should be cleaned every four hours to avoid the consolidation of residual concrete and the normal operation.
8. Every shift should discharge the water accumulated in the air compressor, air storage tank and filter, and eliminate the faults in the operation.
9. Butterfly valve, mixer, solenoid valve, air filter and oil mist device shall be maintained according to relevant instructions.
10. The console of the mixer shall enable the operator to see the working conditions of each part, and the instrument indication signal shall be accurate and reliable. The console of the electric mixer shall be padded with rubber plate or dry wood board.
11. Check the transmission mechanism, working device, brake, etc., which should be fastened and reliable to ensure normal operation. Large gear ring, belt pulley and other parts should be equipped with protective cover.
12. Aggregate specifications shall be consistent with the performance of the mixer, and those beyond the permitted range shall not be used.
13. Add lubricating oil (grease) to worn and rotating parts such as big gear ring and runway.
